Points to pay attention to when installing a heat shrink packaging machine

Heat shrink packaging is currently the most widely used packaging method, and heat shrink packaging machines have also been widely used. How to install heat shrink machine, and what should be paid attention to, let the editor of Lead Machinery explain Everyone answer.

1. The heat shrink packing machine and the winding machine consume a lot of power, so the power of the input power supply must be greater than the nominal power on the shrink machine plate, otherwise it is easy to burn the circuit or electrical components

2. Machines like balers need reliable grounding to protect personal safety.

3. Each machine is attached with a power cable when it leaves the factory, and the lead part of the terminal has the identification symbol of the power supply, which needs to be connected correctly. Violation of regulations may cause electric shock.

4. When the specified voltage of the machine is a three-phase 380V power supply, the zero line is input at the same time, that is, the standard three-phase four-wire system and other packaging equipment are also like vacuum packaging machines. Otherwise, the machine cannot work normally, and it is easy to burn the internal electrical components.

4. When the specified voltage of the machine is a three-phase 380V power supply, the zero line is input at the same time, that is, the standard three-phase four-wire system and other packaging equipment are also like vacuum packaging machines. Otherwise, the machine cannot work normally, and it is easy to burn the internal electrical components.

5. The best automatic packaging machine must be installed horizontally, otherwise the service life of the electric heating tube will be shortened. For machines conveyed by mesh belts, their inclined installation will cause the conveyor belt to be off-center.

6. When the machine has been used continuously for more than three months, the heat-resistant wires in the shrinking chamber should be checked and replaced as appropriate according to their aging degree.

7. When the machine is working, the operator's palm and other parts are not allowed to contact with the running parts of the machine, especially the temperature inside the shrinking chamber is high, which is easy to burn.

8. After the packaging work is finished, turn off the heating switch first, let the conveying motor and fan motor continue to run for about 10 minutes, and then cut off the entire power supply.

The above is the correct way to install the heat shrink packaging machine. The editor hereby reminds everyone to read the manual carefully before installation.

If you don't understand, please contact the manufacturer's engineer to guide the installation.